Operation assignment fails for GCDs with insufficient draft or with edge radii that are too small, provided that you enable the relevant checks by setting one or both of the following setup options:

The following setup options enable wall-thickness feasibility checks at the process level:

Minimum wall thickness checking is disabled by default. If this setup option is enabled, and the wall thickness of a GCD is less than the relevant minimum, Insert Injection Molding is considered infeasible, and costing fails. See Process Feasibility for Insert Injection Molding.

Maximum wall thickness checking is disabled by default. If this setup option is enabled, and the wall thickness of a GCD is greater than the relevant maximum, Insert Injection Molding is considered infeasible, and costing fails. See Process Feasibility for Insert Injection Molding.

Draft angle checking is disabled by default. If this setup option is enabled, and the draft angle of a GCD is less than the relevant minimum, operation assignment fails for that GCD. See Operation Assignment for Insert Injection Molding.

Edge radius checking is disabled by default. If edge radius checking is enabled, and the edge radius of a GCD is less than the relevant minimum, operation assignment fails for the GCD. See Operation Assignment for Insert Injection Molding.