Operation Assignment for Insert Injection Molding

Operation assignment fails for GCDs with insufficient draft or with edge radii that are too small, provided that you enable the relevant checks by setting one or both of the following top-level setup options:

• Draft Angle Check: the lookup table tblDraftAngle specifies the minimum recommended draft angle for each material and process (only Insert Injection Molding is currently supported).

If draft checking is enabled and the draft angle of a GCD is less than the relevant minimum, the GCD fails to cost.

• Minimum Edge Radius Check: the lookup table tblMinEdgeRadius specifies the minimum recommended edge radius for each material and process.

If edge radius checking is enabled, and the radius of a GCD is less than the relevant minimum, the GCD fails to cost.