The Bench Operation Process and the Tool Breakdown component-level operation provide the following options:

(Provided by the Bench Operation process.)

By default, the number of operators is specified by the machine property Number of Operators. With this setup option, users can override the default on a per-part basis. Number of operators drives cycle time—see Inspecting Component-level Operation and Tool Breakdown Component-level Operation.

(Provided by the Tool Breakdown component-level operation.)

This is the time to remove the part from tool after curing. By default, this time is looked up by part Length and Width in the Part Handling Time column of the lookup table tblHandlingTimes. Users can override the default on a per-part basis with this setup option.

Part removal time is a component of labor-dependent process time. See Tool Breakdown Component-level Operation.