Design-to-cost Configuration for Sand Casting

This section covers configuring Design to Cost for the Casting—Die and Casting—Sand process groups. You can configure some of the thresholds that help determine what plastic Issues and thickness violations are listed in the Design to Cost tab.

The following sections cover lookup tables that specify thresholds related to plastic issues (Material Issues, Draft Issues, and Radii Issues):

• Material Issues: Wall Thickness Thresholds

• Draft Issues: Draft Angle Thresholds

• Radius Issues: Edge Radius Thresholds

• Proximity Issues: Hole Proximity Issues

• Hole Issues: Maximum Hole Depth

• Hole Issues: Minimum Hole Diameter

A lookup table related to tolerance and roughness thresholds is covered in Tolerance Grade and Roughness Ranges.