Insert Pick and Place operations provide the following options, which can be set on a per-GCD basis for non-molded Subcomponents:

This is the time it takes to pick one non-molded subcomponent of a part and place into the mold or onto an action mechanism. By default, load time is looked up by part weight and load method (see Manual or Robotic Loading in the lookup table tblComponentLoadTime. For Manual Load, this base load time is adjusted based on any special handling and/or insertion difficulties. See Insert Pick and Place Operation Formulas.

With this setup option, users can override the default on a per-subcomponent basis, and specify the base load time explicitly.

This is a factor that accounts for any special handling difficulties, such as those caused by component nesting, stickiness, or fragility.

By default, no special handling difficulties are assumed; that is, this factor is 1, by default. See Insert Pick and Place Operation Formulas.

With this setup option, users can override the default on a per-subcomponent basis, and do one of the following:

This is a factor that accounts for any special insertion difficulties, for example, difficulties with alignment and positioning due to obstructed access, obstructed vision, or lack-of-alignment features such as chamfers and lead-ins.

By default, no special insertion difficulties are assumed; that is, this factor is 1, by default. See Insert Pick and Place Operation Formulas.

With this setup option, users can override the default on a per-subcomponent basis, and do one of the following: