Width of Addendum Added to Blank Size [per side]

An offset to be added all around the perimeter of the flattened part. You can enter a non-zero value in order to add additional material to the flattened part to account for forms, or for the purpose of holding the blank during the stamping process which is subsequently trimmed away. This value affects machine selection and material utilization.

Select one of the following options:

• No Addendum: this is the default.

• Computed Based on Form Depth: based on lookup by total form depth (see the PSO Total Depth of Forms) in the lookup table blankAddendumWidth.

• User Override: enter a value greater than or equal to 0.