Press French Stop

Specifies whether to use a French stop (a notch on the edge of the coil) in order to keep the coil appropriately aligned with the die stations (the notch acts as a positive stop as the coil advances). If used, extra width must be added to the coil width to provide sufficient space for the notch. Select one of the following options:

• Standard French Stop: add the default extra width for a French stop, the value of the cost model variable defaultFrenchStopSize (3.0 mm in aPriori starting point VPEs).

• No French Stop: no extra width is added. This is the default.

• User Override: enter a value greater than or equal to 0, the width to be added.