Press Carrier Strip Type
Number and position of the carrier strips that are used to convey the stamped blanks from die station to die station. Select one of the following options:
• Default: aPriori chooses a default carrier strip type based on the blank’s SER length (see the PSO Length). A double edge strip is used if the length is greater than the cost model variable largeProgDiePartSizeThreshold; a single edge strip is used otherwise.
• User Override:
o singleEdge: Only one carrier strip is used for each row of blanks, located on one side of the row.
o doubleEdge: Two carrier strips are used for each row of blanks, located on each side of the row.
o center: Only one carrier strip is used for each row of blanks, located in the middle of the row.
