Design-to-cost Configuration for Plastic Molding

This section covers configuring Design to Cost for the Plastic Molding process group. You can configure some of the thresholds that help determine what plastic Issues and thickness violations are listed in the Design to Cost tab.

The following sections cover lookup tables that specify thresholds related to plastic issues (Material Issues, Draft Issues, Proximity Issues, Radus Issues, Hole Issues):

• Material Issues: Wall Thickness Thresholds

• Draft Issues: Draft Angle Thresholds

• Radius Issues: Minimum Internal and External Edge Radius

• Proximity Issues: Hole Proximity Issues

• Hole Issues: Length-to-diameter (L/D) Ratio