Process Defaults and Thresholds for Stretch Forming

Following are some of the important cost model variables for the Stretch Forming process group:

allowableHullToCurveRatio	See Stretch Form Process Feasibility.
defaultApplyLubricantTime	See Cycle Time for the Stretch Form Process.
defaultColdStorageTime	See Formulas for the Cold Storage Process.
defaultFinalInspectionTime	See Formulas for the Bench Operation Process.
defaultIdentingTime	See Cycle Time for the Stretch Form Process.
defaultInterStretchInspectionTime	See Cycle Time for the Stretch Form Process.
defaultLocatingHoleDrillingTime	See Cycle Time for the Stretch Form Process.
defaultManualFormFormingRate	See Formulas for the Bench Operation Process.
defaultManualFormingToolingMultiplier	See Stretch Forming Tooling.
defaultNumStretches	See Routing for Stretch Forming.
defaultRouterJigToolingCost	See Stretch Forming Tooling.
defaultStretchFormToolingCost	See Stretch Forming Tooling.
enableScrapMaterialCredit	See Enable Scrap Material Credit.
enableScrapPartCredit	See Enable Scrap Part Credit.
regionMultiplier	See Stretch Forming Tooling.
stretchFormAlignedMaterialAddendum	See Material Stock Selection for Stretch Forming.
stretchFormOrthogonalMaterialAddendum	See Material Stock Selection for Stretch Forming.
usePreferredMachines	See Machine Selection for Stretch Forming.