Cost drivers | Description | |
---|---|---|
GCD | Name | The name and number that identifies the GCD. This information is an identifier only and is not used in any cost calculation. |
Properties | Bend Angle (deg) | The total angle that the bend passes through. Unbent, this angle equals 0. A hem equals 180 degrees. |
Clock Angle (deg) | Angle measured in a plane perpendicular to the tube/bar axis | |
Bend Direction | Indicates the direction of the bend with respect to the main surface. Possible values include UP, DOWN, BOTH, EITHER, and UNKOWN. | |
Bar Position, From (mm) | Distance from the bar origin to the start of the bend GCD. | |
Bar Position, To (mm) | Distance from the bar origin to the end of the bend GCD. | |
Length (mm) | The length of the GCD. | |
Min Bend Radius (mm) | The minimum radius of any bend surface along the chain measured from the bend interior. | |
Neutral Bend Radius | Radius of bend measured to the neutral axis. | |
Bend Flap Size | The maximum distance between two neighboring bends or a bend and a neighboring blank contour. | |
Is Straight | Indicates whether the bend goes along a line axis. If true, the bend is straight. | |
Is Gusset | Indicates whether the bend has a gusset (a special type of emboss) put across the bend as a strengthener. | |
Technique | Requested | The technique selected by you. If you have not selected a technique, this field is set to auto-select. |
Selected | The technique used by aPriori. If the requested technique cannot be used, aPriori will select a technique that can be used. | |
Results | Status | The costing status of the GCD or technique. A green icon indicates that costing was successful; a yellow icon indicates that costing succeeded with a warning, and a red icon indicates that costing failed. |